Remove the headlight assembly of your car.
Remove the clear lens housing of the headlight. I used a heat gun to apply heat on the sides of the headlight to soften the glue. After removing the clear lens, remove the reflector shield, it secured with a screw on the back of the reflector.
Disassemble the bulb holder of the projector by unscrewing 3 screws.
Install the projector,pass the wire the through the hole where you remove the reflector shield. Screw the nut in the back of the reflector to secure projector in place, do an alignment test before tight-ting the projector. After securing the projector in place, preheat the glue of the headlamp assembly to soften it and put back the whole headlight.
Headlight after projector retrofit: painted with satin black.
